|
| |
TM 9-2320-304-14&P
4-234.35
Organizational Maintenance Instructions (Cont)
d. Assembly.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
NOTE
·
Perform steps (1) through (4) if pin end was removed.
·
If strut bracket and/or long strut is being replaced, refer to f. Adjustment.
·
Position pin end in long strut as noted during disassembly.
(1)
Apply antiseize compound to threads of
pin end (1).
(2)
Position pin end (1) in end of long
strut (2).
(3)
Position cushion clip (3) on pin (4), lock
pin (5), wire rope (6), and swaging
sleeves (7).
(4)
Position cushion clip (3) and screw (8)
on long strut (2).
(5)
Apply antiseize compound to outer
surface of bearing (9).
WARNING
Use care when installing snap and
retaining rings. Snap and retaining rings
are under spring tension and can act as
projectiles when released and could cause
severe eye injury.
(6)
Install bearing (9), spacer (10), and
retaining ring (11) in bore of long
strut (2).
(7)
Install grease fitting (12) in long
strut (2).
Change 1
|
