|
| |
TM 9-2320-304-14&P
4-234.27
Organizational Maintenance Instructions (Cont)
b. Installation.
NOTE
·
Right rear roller bracket and left rear roller bracket are identical unless noted.
·
Right rear roller bracket is shown.
(1)
Position stow plate (1), two screws (2), and locknuts (3) to rear roller bracket (4). Do not tighten
screws.
NOTE
Perform step (2) if wire rope was removed.
(2)
Install swaging sleeve (5) to wire rope (6).
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(3)
Apply sealing compound to threads of screw (7) and screw (8).
(4)
Install screw (8), washer (9), and loop end of wire rope (6) on rear roller bracket (4). Do
not tighten screw.
(5)
Position screw (7), washer (10), and end of wire rope (6) on rear roller bracket (4).
NOTE
Wire must be pulled tight against roller bracket when installed.
(6)
Wrap wire rope (6) around screw (7) and under washer (10) and tighten screw (7) and screw (8).
Change 1
|
