|
| |
TM 9-2320-304-14&P
4-227
Organizational Maintenance Instructions (Cont)
(6) Position screw (13), washer (14),
and locknut (15) in fender support
arm (1) and fender brace (16).
(7) Install two screws (17) and
locknuts (18) in fender support
arm (1).
(8) Tighten locknut (15) on screw (13).
(9) Install self-tapping screw (19) in
fender support arm (1).
NOTE
Push clips are properly installed when
lock button is pushed in after
installation.
(10) Install marker lamp wiring
harness (20) and six push clips
(21) on fender support arm (1).
(11) Install reflector bracket (22),
reflector (23), and two screws (24).
c. Follow-on Maintenance.
(1) Install rear fender side marker lamp (Para 4-42).
(2) Install center mud flap (Para 4-51).
(3) Connect batteries (TM 9-2320-279-20).
(4) Remove wheel chocks (TM 9-2320-279-10).
END OF TASK
|
