|
| |
TM 9-2320-304-14&P
4-152
Organizational Maintenance Instructions (Cont)
4-30. GENERAL WIRE HARNESS REPAIR (CONT).
a. Type 1 Connector Repair.
CAUTION
Terminals come in different styles and
sizes. To prevent damage, be sure to use
only the exact replacements. Do not
attempt to modify terminal to fit.
NOTE
Repeat procedure as necessary.
(1) Disassembly.
(a) Unscrew cover (1).
(b) Slide plastic sleeve (2) back.
(c) Remove wire (3) and terminal (4)
from connector (5).
NOTE
Cut as close to damaged terminal as
possible.
(d) Cut off terminal (4) at end of
wire (3). Remove insulation (6) 1/4
inch (.6 cm) from end of wire (3).
Discard terminal.
(2) Assembly.
(a) Install terminal (1) on wire (2) and
crimp in place.
(b) Install terminal (1) on
connector (3).
(c) Install sealing plugs (4) in unused
holes.
(d) Slide plastic sleeve (5) against
connector (3).
(e) Install cover (6) on connector (3).
|
