|
| |
Malfunction
Test or Inspection
Corrective Action
TM 9-2320-304-14&P
4-108
Organizational Maintenance Instructions (Cont)
4-18. TROUBLESHOOTING INSTRUCTIONS (CONT).
Table 4-3. Load Handling System (LHS) Troubleshooting (CONT)
LOAD HANDLING SYSTEM (LHS) (CONT)
14. MAIN FRAME DOES NOT UNLOAD IN MANUAL MODE (CONT).
WARNING
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive
electrical circuits, a direct short may result. Damage to equipment and injury or death to
personnel may occur.
NOTE
Only remove center screw on engine side of LHS control box cover.
Step 2. Check for 22 to 28 Vdc at main frame up directional control (DC) valve harness connector
terminal 2 with ENGINE switch ON, hydraulic selector switch in MAN M.F. position, and
joystick in UNLOAD position.
If Vdc measurement is below specification, go to Step 3. of this Fault.
If there are 22 to 28 Vdc, go to Step 10. of this Fault.
|
