|
| |
TM 9-2320-304-14&P
2-97
Operating Instructions (Cont)
NOTE
Only remove center screw on engine side of LHS control box cover.
(4) Remove four screws (6), lockwashers (7), and LHS control box cover (8) to gain access to main
manifold valve on left side of truck.
CAUTION
Engine speed must be at idle before hook arm cylinders are fully extended. Damage to
equipment may result.
(5) Unload flatrack from truck as follows:
(a) Press and hold free flow valve override button (9) and manual hook arm UP button (10)
and extend hook arm cylinders (11) until hook arm cylinders are fully extended.
(b) Press and hold free flow valve override button (9) and manual main frame UP button (12)
until unloaded.
CAUTION
To avoid equipment damage make sure that main frame cylinders do not complete full
retraction while operating at engine speeds above idle.
(6) Load flatrack onto truck as follows:
(a) Press and hold manual free flow valve override button (9). Press manual main frame
DOWN button (13) until main frame cylinders (14) are fully retracted.
(b) Press and hold manual override button (9) and depress manual hook arm DOWN
button (15) until flatrack is in transit position.
(c) Press transit valve button (16) before moving truck.
|
