|
| |
TM 9-2320-304-14&P
2-82.154
Operating Instructions (Cont)
2-10.11 REMOVING AND INSTALLING FRONT LIFT ADAPTER FROM TRUCK (CONT).
(17)
Start engine (TM 9-2320-279-10).
NOTE
·
To disengage LHS hook arm from front lift adapter hook, it may be necessary to
cycle LHS to unload after driving ahead slightly.
·
LHS will only operate when transmission range selector is in N (Neutral).
·
If ground is soft, jacking plate from truck BII or similar item may be positioned
under support leg pad to prevent front lift adapter from sinking in ground.
(18)
Move joystick (5) to UNLOAD until LHS stops and hook (16) is below front lift adapter hook
bar (17).
(19)
Set transmission range selector (18) to D (Drive) and move truck ahead approximately
12 in. (30 cm).
(20)
Apply service brake pedal (19), set transmission range selector (18) to N (Neutral), and pull out
parking brake knob (20) to apply parking brake.
(21)
Turn hydraulic selector switch (4) to OFF.
(22)
Put PTO ENGAGE switch (2) in OFF position. Make sure indicator light (3) goes off.
(23)
Shut off engine (TM 9-2320-279-10).
Change 1
|
