|
| |
TM 9-2320-304-14&P
2-82.123
Operating Instructions (Cont)
CAUTION
·
On steep downgrades, contact is possible between the front lift adapter lower legs
and the rear sliders during empty LHS cycles. If contact appears likely, switch
hydraulic selector to MAN H.A. position and retract (LOAD) hook arm a few inches.
Switch hydraulic selector to MAN M.F. position and retract the main frame until
the front lift adapter clears the rear sliders. Return hydraulic selector to AUTO and
continue (LOAD) operation. Failure to comply may result in damage to equipment.
·
Never drive with LHS NO TRANS lamp illuminated. An illuminated lamp means
that the LHS is not fully stowed. Failure to comply may result in damage to
equipment.
NOTE
The amount of time to load and unload is controlled by engine speed. Engine speed can be
increased to approximately 1500 rpm to reduce loading and unloading times.
(30)
Move joystick (10) to LOAD position until LHS is fully retracted and front lift adapter (20) is
positioned on bumper supports (21). LHS NO TRANS lamp (12) will go off, indicating LHS is in
transport position.
(31)
Release joystick (10).
CAUTION
·
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
·
Hydraulic selector switch must be in the OFF position before driving truck, or
hydraulic system could overheat.
(32)
Turn hydraulic selector switch (9) to OFF.
(33)
Put PTO engage switch (7) in OFF position. Make sure indicator light (8) goes off.
Change 1
|
