|
| |
TM 9-2320-304-14&P
2-82.104
Operating Instructions (Cont)
2-10.5 LOADING AND UNLOADING CONTAINER (48 INCHES [122 CM] OR TALLER)
TO TRUCK USING FRONT LIFT ADAPTER (FLA) (CONT).
(25)
Position half-height container front hooks (13) just above and in front of half-height container
upper front corner castings (22).
NOTE
LHS will only operate when transmission range selector is in N (Neutral).
(26)
Apply service brake pedal (4) and set transmission range selector (5) to R (Reverse).
WARNING
Do not allow front lift adapter to contact the ground when half-height container front hooks
are not engaged with container upper corner castings. Failure to comply may result in
damage to equipment and injury or death to personnel.
(27)
Release service brake pedal (4) and slowly back up to approximately 12 in. (30 cm) from front of
container (6).
(28)
Apply service brake pedal (4), set transmission range selector (5) to N (Neutral), move
joystick (10) to LOAD, and raise front lift adapter until half-height container front hooks (13)
are above container upper front corner castings (22).
CAUTION
Make sure half-height container front hooks are fully engaged with container upper front
corner castings. Failure to comply may result in damage to equipment.
NOTE
To get half-height container front hooks to properly seat, it may be necessary to drive truck
forward slightly.
(29)
Release service brake pedal (4) and, moving joystick (10) to UNLOAD, lower half-height
container front hooks (13) into half-height container upper front corner castings (22).
(30)
Set transmission range selector (5) to R (Reverse), move truck backward approximately 12 in.
(30 cm).
Change 1
|
