| |
TM 9-2320-304-14&P
2-67
Operating Instructions (Cont)
CAUTION
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
(8) Release the joystick (8) and turn hydraulic selector switch (7) to MAN M.F. position.
(9) Hold joystick (8) in UNLOAD position until lift hook (10) has moved below level at flatrack hook
bar (11).
NOTE
LHS will only operate when transmission range selector is in N (Neutral).
(10) Set transmission range selector (4) to R (Reverse) and release service brake pedal (3). Back
truck up until lift hook (10) contacts hook bar (11).
(11) Pull out PARKING BRAKE control (12).
CAUTION
·
Ensure that trailer drawbar is down against the ground or damage to equipment
may result.
·
Both of the trailer bumper points must be under the truck bumper stop flange and
at least one of the bumper points must be within 3.5 in. (89 mm) of the bumper stop.
The other trailer bumper point cannot exceed 0.5 in. (13 mm) difference in distance
or flatrack will miss main rail guides and equipment damage may result.
(12) Check that trailer bumper (13) is under flange of truck bumper stop (14).
|