 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-2
FRONT SPRING REPLACEMENT - CONTINUED
0282 00
REMOVAL - CONTINUED
8.
With assistance, remove spring (12), spacer (23), shock absorber bracket (22), shim(s) (21), and pin (20) from front axle
(15).
28
18
18
27
26
19
12
24
25
19
23
22
21
15
20
INSTALLATION
WARNING
Shim(s) is used to adjust caster alignment. Failure to install shim(s) correctly will cause hard steering and
could result in injury to personnel.
1.
With assistance, install pin (20), shim(s) (21), shock absorber bracket (22), spacer (23), and spring (12) on front axle
(15).
NOTE
Install pin so that grooves line up with holes in shackle, allowing screws to be installed.
2.
Install pin (24) and two washers (19) in spring (12).
3.
Using floor jack, raise front axle (15) so that front end of spring (12) is positioned in front spring hanger (28). Install two
saddle caps (18), four washers (27), screws (26), and grease fitting (25). Tighten screws to 50 lb-ft (68 Nm).
4.
Install pin (10), four shims (9), two wear plates (8), shackles (6), washers (5), screws (7), nuts (4), and grease fitting (11)
in rear spring hanger (3).
5.
Position spring (12) in two shackles (6) and install four shims (9), two wear plates (8), and pin (10).
0282 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals