Disassemble Interaxle Differential cont'd

TM 9-2320-303-24-2

FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED

0257 00

DIFFERENTIAL CARRIER DISASSEMBLY - CONTINUED

(5)

Lift out the interaxle differential (57) from the carrier housing (59).

NOTE

The rear side gear and rear input bearing will remain loose in the carrier housing. (Refer to step (8)).

402-662

(6)

Match-mark the case halves (64 and 67) with a punch for correct alignment at reassembly.

(7)

Disassemble the case halves (64 and 67) by removing eight rivets (69). Remove the spider (68), four pin-

ions (66), and thrust washers (65).

(8)

Lift out the rear side gear (63) and bearing cone (62) from the carrier (59). The bearing cup (61) will

remain in the carrier. If replacement is necessary, remove the cup using a suitable bearing puller.

(9)

To remove the bearing cone (62) from the rear side gear (63), place the gear in a press. Use a suitable

sleeve and press the gear from the bearing cone. If a press is not available, use a suitable bearing puller.

402-229

0257 00-13