OUTPUT SHAFT REMOVAL AND DISASSEMBLY

TM 9-2320-303-24-2

FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED

0257 00

OUTPUT SHAFT REMOVAL AND DISASSEMBLY - CONTINUED

NOTE

The oil seal, snap ring spacer and bearings will remain in the bearing cage. If disassembly is required, con-

tinue with step b; otherwise set aside for assembly.

(2)

Remove the oil seal (5) from the cage (12), using a suitable tool such as a screwdriver to pry seal out. Be

careful not to damage the inner diameter of the cage. Discard seal after removal.

(3)

Remove the retaining ring (6) from its groove in the cage inner diameter using retaining ring pliers.

(4)

Remove washer (7), two bearing cups (10) and two bearing cones (11) from cage (12).

DIFFERENTIAL CARRIER DISASSEMBLY

Remove Gear Cover Assembly.

(1)

Place the complete differential carrier (19) in a suitable repair stand. Lift the unit by the input (front) yoke

(15) using a chain fall.

(2)

Place the differential carrier (19) in an upright position (input yoke pointing upward).

(3)

Using a suitable wrench or socket, loosen the input yoke nut (16). However, do not remove. Leave the nut

and yoke on the input shaft at this time to facilitate gear cover (17) removal.

402-652

0257 00-3