 |
|||
|
|
|||
|
Page Title:
OUTPUT SHAFT REMOVAL AND DISASSEMBLY |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-2
FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
0257 00
OUTPUT SHAFT REMOVAL AND DISASSEMBLY
Removal.
a.
(1)
Disconnect inter-axle driveline from yoke (3) of output shaft (14). (Refer to WP 0116 00).
NOTE
It may be necessary to use a yoke puller to remove the yoke from the shaft.
(2)
Remove nut (1), washer (2), yoke (3) and bushing (4) from output shaft (14).
(3)
Remove four capscrews (8) and washers (9) and pull the cage (12) and shaft assembly from the axle hous-
ing. To free the cage from the housing, it may be necessary to tap the shaft and cage with a soft mallet.
Care must be taken not to damage seal. Remove and discard gasket (13).
Disassembly.
b.
CAUTION
The spacer diameter must be less than the outer diameter of the output shaft to avoid damaging the oil seal
and bearings.
1
2
3
4
8
5
6
9
7
10
11
10
12
13
14
402-651
(1)
Press the output shaft (14) from the cage (12) by placing the shaft and cage in a press. Position cage to the
top. Use a spacer against the output shaft threaded end and press the output shaft from the cage.
0257 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals