 |
|||
|
|
|||
|
Page Title:
Rotating Clutch Module Disassembly - Continued |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-2
TRANSMISSION OVERHAUL - CONTINUED
0248 00
MODULE OVERHAUL - CONTINUED
Rotating Clutch Module Disassembly - Continued
d.
Reaction plate thickness: minimum thickness allowed is 0.095 in (2.41 mm).
e.
Reaction plate cone: maximum cone allowed is 0.010 in (0.25 mm).
6.
Remove C2 (17) and C1 (18) drive hubs with two thrust bearings (16). Measure drive hub splines. Maximum allowable
spline wear is 0.015 in (0.38 mm).
7.
Remove C1 retaining ring (13), two backplates (10), seven friction plates (11), and six steel reaction plates (12). Perform
the following measurements:
a.
Friction plate thickness: minimum thickness allowed is 0.115 in (2.92 mm).
b.
Friction plate oil groove depth: minimum depth allowed is 0.008 in (0.20 mm).
c.
Friction plate cone: maximum cone allowed is 0.010 in (0.25 mm).
d.
Reaction plate thickness: minimum thickness allowed is 0.095 in (2.41 mm).
e.
Reaction plate cone: maximum cone allowed is 0.010 in (0.25 mm).
f.
Backplate thickness: minimum thickness allowed is 0.311 in (7.90 mm).
g.
Backplate flatness: maximum allowable distortion is 0.006 in (0.15 mm).
8.
Remove thrust bearing (7) from clutch hub assembly (6).
9.
Remove retaining ring (8) and turbine shaft (2) from clutch hub (6).
10.
Inspect and measure bushing (3) inside end of turbine shaft (2). Maximum ID allowed is 1.423 in (36.14 mm).
11.
Remove three seal rings (4) and O-ring (1) from turbine shaft (2). Discard O-ring.
0248 00-23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals