 |
|||
|
|
|||
|
Page Title:
Torque Converter Module Assembly - Continued |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-2
TRANSMISSION OVERHAUL - CONTINUED
0248 00
MODULE OVERHAUL - CONTINUED
Torque Converter Module Assembly - Continued
3.
Install thrust washer (23) and thrust plate (24) on stator assembly (19).
4.
Install star plate (26) and retaining ring (25).
5.
Install bearing assembly (16), race (17), and selective shim (18) to pump assembly (13).
CAUTION
When installing thrust bearings, ensure that locating lip on either inner or outer thrust bearing race is not pre-
venting race from contacting thrust surface of mating part. Failure to follow this caution leads to premature
thrust bearing failure and incorrect shim selection to maintain proper internal part clearance.
6.
Install thrust bearing assembly (27) into turbine assembly (28).
7.
If removed, install new bushing (3) into cover assembly (2), using installer tool (J39949).
8.
Insert turbine assembly (28) into converter cover bushing (10). Check for free rotation.
9.
Install thrust bearing (10) in cover assembly (2).
10.
Install lockup clutch piston inner seal ring (4) on hub of cover assembly (2).
11.
Install lockup clutch piston outer seal ring (7) on outside diameter of lockup clutch piston (5).
12.
Install lockup clutch piston (5).
13.
Install lockup clutch damper assembly (8) in cover assembly (2).
14.
Install lockup clutch backup plate (9). Secure backup plate with 44 bolts (11). Tighten bolts to 22-26 lb-ft (30-35 Nm).
15.
Install turbine (28) into cover assembly (2), aligning balance mark on turbine with balance mark on lockup clutch
damper assembly (8).
16.
Install stator assembly (19) in cover assembly (2).
17.
Install 36 T-headed bolts (12) into flange of pump assembly (13).
18.
Install thrust bearing race (14) into pump assembly (13).
19.
Install O-ring (15) onto cover assembly (2).
20.
With balance marks aligned, position pump assembly (13) over cover assembly (2).
21.
Install four nuts (1) evenly spaced around cover assembly (2) onto T-headed bolts (12). Tighten nuts to 22-26 lb-ft (30-
35 Nm).
0248 00-12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals