TURN SIGNAL (THRU-DECK) WIRING HARNESS REPLACEMENT

TM 9-2320-303-24-2

TURN SIGNAL (THRU-DECK) WIRING HARNESS REPLACEMENT

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Materials/Parts

Maintenance Level

Straps, tiedown (Item 41, WP 0312 00)

Direct Support

Equipment Condition

Tools and Special Tools

Master battery switch in OFF position (TM 9-2320-

Tool kit, general mechanic's (Item 102, WP 0313

303-10)

REMOVAL

NOTE

Procedure is the same for both wiring harnesses.

Wiring harness and leads are secured in place by clips, wire ties, cushion clamps, and screw terminals.

Only remove hardware securing harness or lead to be removed.

Disconnect and remove turn signal (thru-deck) wiring harness using illustration and table as a guide.

INSTALLATION

NOTE

Procedure is the same for both wiring harnesses.

Wiring harness and leads are secured in place by clips, wire ties, cushion clamps, and screw terminals.

Make sure harness is secure and all hardware is tight.

Install and connect turn signal (thru-deck) wiring harness using illustration and table as a guide.