COLLISION WARNING SYSTEM (CWS) ANTENNA ALIGNMENT

TM 9-2320-303-24-1

COLLISION WARNING SYSTEM (CWS) ANTENNA ALIGNMENT

THIS WORK PACKAGE COVERS

Vertical Alignment, Horizontal Alignment

INITIAL SETUP

Support Equipment

Tools and Special Tools

Suitable Target Vehicle

Tool kit, general mechanic's (Item 102, WP 0313

Personnel Required

CTIS/CWS PC card (Item 65, WP 0313 00)

Three

Level, digital (Item 55, WP 0313 00)

Equipment Condition

Tester, Pro-link diagnostic reader (Item 99, WP

Vehicle parked on level ground

NOTE

To ensure accurate alignment of CWS antenna, vertical and horizontal ground surface angles must be

known in relation to level and compensated for during antenna alignment.

Always perform vertical alignment first.

VERTICAL ALIGNMENT

Place digital level (4) vertically on CWS antenna (1). Take reading to determine which direction antenna must be

adjusted.

Loosen four screws (3) on side of CWS antenna (1) enough to allow repositioning of antenna without free travel.

Holding digital level (4) vertically on CWS antenna (1), pivot top or bottom of antenna until reading on level is at least

1 degree below vertical (88.0-89.0 degrees).

Proceed to horizontal alignment.