 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
CAB DOOR ADJUSTMENT - CONTINUED
0175 00
ADJUSTMENT - CONTINUED
13.
Install six new self-tapping screws (1) and tighten screws and two adjusting screws (2 and 3) in order shown to 120 lb-
in. (1360 Ncm).
ORDER OF
ADJUSTMENT
7
1
5
1
2
3
1
4
3
2
6
1
8
14.
Close cab door (9) to within 2 in. of striker pin (13) and look to see if door latch jaws (12) will be centered on striker pin.
12
9
13
12
15.
Loosen torx screw (15) and add or remove shims (14) as necessary to center striker pin (13) and door latch jaws (12).
NOTE
Steps 16 through 19 must be performed from inside and outside of cab.
Repeat step 16 until door closes fully without difficulty.
16.
Fully close cab door (9). If cab door was difficult to close or would not close, open cab door, loosen torx screw (15), and
move striker pin (13) inward.
17.
Tighten torx screw (15) to 50 lb-ft (68 Nm).
0175 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals