CODE 22 XX -- SPEED SENSOR/CIRCUITRY FAULT (Figure 55)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL

CODE 22 XX -- SPEED SENSOR/CIRCUIS RY FAULT (Figure 55)

DIAGNOSTIC CODE T

5. If the condition again recurs, connect the diagnostic tool and select the speed signal indicated by

the trouble code. Drive the vehicle and watch the speed reading on the diagnostic tool. If the signal

is erratic, sensor gap, vehicle vibration, an external AC signal source, or intermittent connector

contact may be inducing the erratic signal. Inspect the sensor and its surroundings for irregularities

that would affect sensor gap. Isolate and correct any abnormal vehicle vibrations (particularly

driveline and abnormal engine torsionals. Recheck the sensor wiring for intermittent conditions

6. If the condition persists, replace the ECU. If replacing the ECU corrects the problem, reinstall the

original (bad) ECU to confirm that the problem is in the ECU. If the original ECU now works,

inspect the ECU connectors for any corrosion or damage which may cause an intermittent

condition. If the original problem recurs, reinstall the replacement ECU.

0021 0060