 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
REAR HUB, DRUM, WHEEL BEARINGS, AND SEAL REPLACEMENT - CONTINUED
0209 00
REMOVAL - CONTINUED
CAUTION
Ensure axle hub studs are not damaged during axle shaft removal. If damage occurs, replace stud to allow
proper installation of tapered dowels and nuts.
NOTE
Have suitable container available to catch oil that will spill when axle shaft is removed.
2.
Remove eight nuts (8), washers (9), axle shaft (10), and gasket (11). Discard gasket.
3.
Remove jamnut (12), lock ring (13), and adjusting nut (14) from axle spindle (1).
4.
Remove outer wheel bearing (15) from axle spindle (1).
5.
Remove hub (5) from axle spindle (1).
6.
Remove and discard seal (2) from hub (5).
7.
Remove inner wheel bearing (3) from hub (5).
8.
If damaged, remove eight studs (6) from hub (5).
NOTE
Perform step 9 if bearing cups are damaged or if installing new wheel bearings.
9.
Using brass drift pin, carefully remove and discard two bearing cups (4) from hub (5).
NOTE
The following step applies only to rear-rear axle hub.
ABS tone ring must be replaced if ring is damaged or if replacing hub.
To remove ABS tone ring (16) from hub (5), use a small pry bar or hammer to gently pry off ring. Use a circular pattern
around ring to prevent cocking.
1
2
3
4
5
6
7
16
4
15
14
13
8
12
9
11
10
0209 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals