AUTOMATIC STARTING AID REMOVAL

TM 9-2320-302-20-2

AUTOMATIC ETHER STARTING AID MAINTENANCE - CONTINUED

0039 00

AUTOMATIC STARTING AID REMOVAL - CONTINUED

Remove four bolts (7), washers (11), nuts (12), and ether control relay (13) from ether control relay bracket (10).

Remove ether control relay bracket (10) from fuel cylinder bracket (2) by removing two bolts (24), four washers (5), and

two nuts (6) on right side of fuel cylinder bracket.

NOTE

Valve with harness attached is permanently attached to fuel cylinder bracket.

Remove fuel cylinder bracket only if damaged.

Remove two remaining bolts (24), four washers (5), two nuts (6), ground wire (23), and fuel cylinder bracket (2) from

frame bracket (19).

10.

Remove three bolts (20), washers (17), nuts (18), and frame bracket (19) from frame.

AUTOMATIC STARTING AID INSTALLATION

Position frame bracket (19) on frame and install three bolts (20), washers (17), and nuts (18).

NOTE

Perform step 2 if fuel cylinder bracket was removed.

Position fuel cylinder bracket (2) on frame bracket (19) and install two bolts (24), ground wire (23), four washers (5)

and two nuts (6) on left side of bracket.

Position ether control relay bracket (10) on fuel cylinder bracket (2) and install remaining two bolts (24), four washers

(5), and two nuts (6).

Install clamp (26) on fuel cylinder bracket (2).

WARNING

Ether fuel is extremely flammable and toxic. DO NOT smoke and make sure you are in a well-ventilated

area away from heat, open flames or sparks. Wear eye protection and chemical resistant gloves. Avoid con-

tact with skin and eyes and avoid breathing ether fumes. If fluid enters or fumes irritate the eyes, wash

immediately with large quantities of clean water for 15 minutes. Seek medical attention immediately if ether

is inhaled or causes eye irritation. Failure to follow this warning may cause death or serious injury to person-

nel.

NOTE

Fitting has left-hand threads. Turn left to install fitting.

Install fitting (22) on valve (25) with opening in fitting toward rear of vehicle.

Position ether control relay (13) on ether control relay bracket (10) and install four bolts (7), washers (11), and nuts (12).

CAUTION

Orientation mark of atomizer nozzle must be positioned so that orifice is facing against air flow of intake

manifold. This will ensure proper dispersal of ether. Failure to install atomizer nozzle with orifice oriented

properly may cause damage to engine from improper dispersal of ether.

0039 00-3