|
| |
TM 9-2320-270-10
OPERATING WINCHES - CONTINUED
Operating NO. 2 WINCH
1.
2.
3.
NOTE
Engine may be shut down to stop winching operation if necessary by using
engine shutdown control (1). See page 2-92.
Pull engine throttle control (2) as far back as it will go (toward cab). Main transmission
will shift through its 2 to 5 range.
Check instrument panel tachograph (3) after final up-shift. Engine speed should stabi-
lize at about 2200 rpm (4).
Move NO. 2 WINCH low speed lever (5) forward to pay out cable, and backward to
take up cable at low speed.
C A U T I O N
Never operate a winch at high speed when there is a load on the winch cable.
High speed is intended for no-load operation only. Failure to follow this
caution can result in equipment damage.
4. For high speed operation, move high speed lever (6) and low speed lever (5) at the same
time and in the same direction. Move both levers forward to pay out cable and backward
to take up cable at high speed.
2-96
|
