Figure 4-28. Fuel system (Sheet 2 of 2)

TM 55-1740-200-14

1. Adapter

23. Stud

45. Shaft

2. Elbow

24. Washer

46. Bracket

3. Plug

25. Nut

47. Screw

4. Strap

26. Gasket

48. Washer

5. Nut

27. Governor

49. Nut

6. Cap

28. Gasket

50. Nut

7. Tank

29. Adapter

51. Washer

8. Clamp

30. Adapter

52. Ball joint

9. Screw

31. Screw

53. Nut

10. Washer

32. Gasket

54. Rod

11. Nut

33. Nut

55. Pedal

12. Tube assembly

34. Washer

56. Pin

13. Adapter

35. Ball joint

57. Pin

14. Hose assembly

36. Nut

58. Plate

15. Elbow

37. Rod

59. Screw

16. Pump assembly

38. Spring

60. Washer

17. Screw

39. Lever

61. Nut

18. Washer

40. Screw

62. Elbow

19. Air cleaner

41. Washer

63. Line assembly

20. Washer

42. Nut

64. Connector

21. Carburetor assembly

43. Setscrew

65. Gasket

22. Stud

44. Spacer

66. Line assembly

Figure 4-28. Fuel system (Sheet 2 of 2)

4-308. PARKING BRAKES.

4-305. ENGINE COOLING GROUP.

4-309 . PARKING BRAKE AND DIFFERENTIAL

4 - 3 0 6 . REMOVAL. See figure 4-33 and remove the

LOCKOUT LEVERS.

engine cooling components as follows:

4-310. REMOVAL. See figure 4-34 and remove the

a. Remove two clamps (9) and hose (8). Remove two

parking brake and differential lockout levers as follows:

screws (11) and remove housing (10), two gaskets (12 and

13) and thermostat (14).

a. Remove two cotter pins (7) and two pins (8) and

remove link assembly. Remove two clevis (9) and two

b. Remove belt (4). Remove four screws (2) and

nuts (10) from rod (11). Remove two cotter pins (12)

washers (3) and remove fan (1) and pulley (5). Remove

and two pins (13) and remove link assembly. Remove two

pin (7) and hub (6). Remove four screws (15) and remove

clevis (14 and 15) and two nuts (16) from rod (17).

pump assembly and gasket (16).

b. Remove rubber grip (1) and lubrication fitting (2).

c. Remove three screws (18), and one washer (19) and

Remove cotter pin (4), washer (5) and spring (6) and

remove plate (17) and gasket (20). Remove impeller (22)

remove differential lockout lever (3) from bracket (47).

and thrower (26). Remove retaining ring (23), washer

(25) and seal (25) from impeller (22). Remove clip (21)

c. Remove cotter pin (19) and washer (20) and

and shaft (27) from pump housing (28).

remove lever (18) from bracket (50). Remove four screws

(51) and four washers (52) and remove bracket (50).

4-307. DISASSEMBLY. None required.

4-67