ROLL-OVER PROTECTION (ROPS) REPLACEMENT-continued

TM 5-2420-224-34

ROLL-OVER PROTECTION (ROPS) REPLACEMENT (CONT)

General Safety Instructions (Cont):

General Safety Instructions:

WARNING

Adhesive causes immediate

High pressure hydraulics [oil

bonding on contact with eyes,

under 2450 psi (16,893 kPa)]

skin, or clothing and also gives

o p e r a t e this equipment. Never

off harmful vapors. Wear

disconnect any hydraulic line or

p r o t e c t i v e goggles and use in

fitting without first dropping

w e l l - v e n t i l a t e d area. If adhesive

pressure to zero. A high

g e t s in eyes, try to keep eyes

p r e s s u r e oil stream can pierce

o p e n ; flush eyes with water for

b o d y a n d ca u s e se v e r e i n j u r y

1 5 minutes and get immediate

t o personnel.

m e d i c a l attention.

REMOVAL

NOTE

Procedure is the same for both

vehicles.

REMOVE six BOLTS (1) and six nuts (2).

REPEAT STEP 1 for other side and REMOVE

BRACKET (3).

10-2