INSTALLATION-continued -714670124

TM 5-2420-224-34

FUEL INJECTION PUMP REPLACEMENT (CONT)

WARNING

A d h e s i v e causes immediate bonding on contact with eyes, skin, or clothing and

also gives off harmful vapors, Wear protective goggles and use in

well-ventilated area. If adhesive gets in eyes, try to keep eyes open; flush eyes

w i t h water for 15 minutes and get immediate medical attention.

CAUTION

M a k e sure all gasket material has been removed from mating surfaces to

p r e v e n t damage to equipment.

NOTE

Make sure FB mark on timing pointer is alined with FB mark on vibration damper.

Rotate gear on fuel injection pump so that marked tooth will aline with arrow in

timing gear case, when installed.

APPLY COAT of SEALING COMPOUND to THREADS of five screws (11).

INSTALL new gasket (12), fuel injection PUMP (6), and five screws (11).

3-47