AIR CLEANER RESTRICTOR INDICATOR LIGHT WILL NOT LIGHT.

TM 5-2420-224-20-1

Table 3-5. Troubleshooting (Cont)

Malfunction

Test or Inspection

Corrective Action

ELECTRICAL SYSTEM (CONT)

57. AIR CLEANER RESTRICTOR INDICATOR LIGHT WILL NOT LIGHT.

NOTE

Refer to wiring diagram (page 3-183) for all wiring repair steps.

Step 1. Pull instrument cluster panel light (1) out of dashboard (2).

Step 2. Remove air cleaner restrictor indicator lamp (3) and check for continuity.

If there is no continuity, replace lamp.

If there is continuity, go to step 3.

NOTE

Vehicle MASTER disconnect switch must be ON, ignition switch set to ON, and master

light switch set to PANEL BRT. Failure to do so will cause erroneous results.

Step 3. Check for +24 VDC between wire 372 (4) and ground at instrument cluster

panel light (1).

If +24 VDC is not present, repair wiring 372 between

instrument cluster panel light and fuse box 1.

If +24 VDC is present, go to step 4.

Step 4. Set master light switch to OFF and connect jumper across air cleaner

restrictor indicator switch terminals (5). Set master light switch to PANEL

BRT and check if air cleaner restrictor indicator light is lit.

If air cleaner restrictor indicator light is lit, replace air cleaner

restrictor indicator switch (page 4-205).

If air cleaner restrictor indicator light is not lit, repair

wiring 371 between instrument cluster panel light and air

cleaner restrictor indicator switch.