CHARGE INDICATOR LIGHT STAYS ON DURING OPERATION.

5-2420-224-20-1

Table 3-5. Troubleshooting (Cont)

Malfunction

Test or Inspection

Corrective Action

ELECTRICAL SYSTEM (CONT)

43. CHARGE INDICATOR LIGHT STAYS ON DURING OPERATION.

NOTE

If STE/ICE-R CI Engine GO-NO GO Chain does not diagnose cause of problem,

return to this troubleshooting table.

Refer to wiring diagram for all wiring repair steps.

Step 1. Perform STE/ICE-R CI Engine GO-NO GO Chain test procedures in the DCA

diagnostic mode.

If malfunction is found, refer to List of Tasks (page iii) or

Alphabetical Index (page Index-1) and repair or replace

damaged or faulty components.

If malfunction is not found, go to step 2.

NOTE

For steps 2 and 3, engine must be running.

Step 2. Disconnect connector D (1) and check for +24 VDC between wire 34 (2)

and ground.

If +24 VDC is present, repair wiring 34 between connector D

and indicator (gage).

If +24 VDC is not present, reconnect connector D and go to

step 3.

Step 3. Check for +24 VDC between wire 34 (2) and ground at suppressor filter (3).

If +24 VDC is not present, replace suppressor filter

(page 4-235).

If +24 VDC is present, repair wiring 34 between connector D

and suppressor filter.