HIGH BEAM INDICATOR LIGHT WILL NOT LIGHT.

TM 5-2420-224-20-1

Table 3-5. Troubleshooting (Cont)

Malfunction

Test or Inspection

Corrective Action

ELECTRICAL SYSTEM (CONT)

42. HIGH BEAM INDICATOR LIGHT WILL NOT LIGHT.

NOTE

Vehicle MASTER disconnect switch must be ON, master light switch set to SER

DRIVE, and horn, low beam/high beam switch set to HI. Failure to do so will cause

erroneous results.

Refer to wiring diagram for all wiring repair steps.

Loosen two captive screws (1) and pull bracket (2) out enough to gain

Step 1.

access to area behind bracket.

Remove two clamps (3) and pipe assembly (4).

Step 2.

Step 3.

Check for +24 VDC between wire 41HL1 (5) and ground at indicator (gage)

(6).

If +24 VDC is present, replace high beam indicator lamp (7).

If +24 VDC is not present, repair wiring 41HL1.