|
|
TM
5-2420-224-20-1
Table 3-5. Troubleshooting (Cont)
Malfunction
Test or Inspection
Corrective Action
ELECTRICAL SYSTEM (CONT)
30. LEFT FRONT MARKER LIGHT WILL NOT LIGHT.
NOTE
Vehicle MASTER disconnect switch must be ON and master light switch set to SER
DRIVE. Failure to do so will cause erroneous results.
Refer to wiring diagram for all wiring repair steps.
Step 1. Check for +24 VDC between wire 41C2 (1) and ground at quick disconnect
(2).
If +24 VDC is present, replace lamp (3) (page 4-183).
If +24 VDC is not present, go to step 2.
Step 2. Disconnect connector F (4) and check for +24 VDC between wire 41C2 (1)
and ground.
If +24 VDC is present, repair wiring 41C2 between connector F
and lamp.
If +24 VDC is not present, reconnect connector F and go to
step 3.
Step 3. Check for +24 VDC between wire 41C2 (1) and ground at fuse box 2 (5).
If +24 VDC is not present, replace fuse.
If +24 VDC is present, repair wiring 41C2 between fuse box 2
and connector F.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |