LEFT FRONT TURN SIGNAL WILL NOT LIGHT.

5-2420-224-20-1

Table 3-5. Troubleshooting (Cont)

Malfunction

Test or Inspection

Corrective Action

ELECTRICAL SYSTEM (CONT)

29. LEFT FRONT TURN SIGNAL WILL NOT LIGHT.

NOTE

Vehicle MASTER disconnect switch must be ON, master light switch set to SER

DRIVE, and turn signal lever switched to L. Failure to do so will cause erroneous

results.

Refer to wiring diagram for ail wiring repair steps.

Step 1. Check for +24 VDC between wire 45FL (1) and ground at quick disconnect

(2).

+24 VDC is present, replace lamp (3) (page 4-183).

+24 VDC is not present, go to step 2.

Step 2. Disconnect connector G (4) and check for +24 VDC between wire 45FL (1)

and ground.

If +24 VDC is present, repair wiring 45FL between connector G

and lamp.

If +24 VDC is not present, reconnect connector G and go to

step 3.

Step 3. Check for +24 VDC between wire 45FL (1) and ground at turn signal lever

(5).

If +24 VDC is not present, replace turn signal lever

(page 4-1 22).

If +24 VDC is present, repair wiring 45FL between turn signal

lever and connector G.