Table 3-5. Troubleshooting (Cont) -680640206

5-2420-224-20-1

Table 3-5. Troubleshooting (Cont)

Malfunction

Test or Inspection

Corrective Action

ENGINE (CONT)

Step 21. Disconnect connector D (3). With engine start switch and starter switch

depressed, check for +24 VDC between wire 213 (22) and ground.

If +24 VDC is not present, repair wiring 213 between

connector D and relay K1.

If +24 VDC is present, reconnect connector D and go to

step 22.

Step 22. With engine start switch and starter switch depressed, check for +24 VDC

between wire 213 (22) and ground at starter (23).

NOTE

If starter is determined to be defective, perform Malfunction 2 prior to replacing starter.

If +24 VDC is present, replace starter (page 4-117).

If +24 VDC is not present, repair wiring 213 between starter

and connector D.

3-76