Mounting Left Side Panel.

TM 5-2420-224-10

(1)

Position the rear panel assembly on the top of the front panel assembly with the thermal tape

facing toward the rear.

c. Mounting Left Side Panel.

(1)

Remove the left side panel from the frame assembly.

(2)

Position the frame on the left side door to the lower rear of the door. Frame opening should point

up.

(3)

When an acceptable position is obtained, mark the outline of the left side panel frame on the door.

(4)

Thoroughly clean marked area of the door with Ethyl Alcohol (NSN 6810-00-127-4532) and let dry.

(5)

Spray the door area that will be covered by the Velcro Hook with tape adhesive primer (NSN 8040-

00-938-6860). Remove the protective backing from the Velcro Hook which is attached to the Velcro

Pile on the panel frame.

(6)

Position the left side panel frame on the marked outline of the door and firmly press into place.

(7)

Install the louvered panel insert into the frame with the thermal tape on arrow facing away from the

vehicle.

d. Mounting Right Side Panel .

NOTE

To conceal the exposed thermal tape, remove the insert, reverse the insert, and

reinstall insert into the frame. When installing insert with the thermal tape side

exposed, insure the thermal tape arrow faces out.

(1)

Repeat steps 1 - 7 above to install the right side panel.

Change 1

2-151/(2-152 Blank)