|
| |
TM 5-2420-222-34
3-4.
ENGINE BLOCK MAINTENANCE (Con’t).
d.
ASSEMBLY
1.
If removed, install two pins (9) in engine block (1) with ball-peen hammer.
2.
Install pipe plug (10), four fluid restrictors (11), and side plug (8) in engine block (1).
3.
If removed, install three studs (4) in engine block (1) using stud remover and setter.
4.
If removed, install two pins (7) in engine block (1) with ball-peen hammer.
5.
If removed, install sleeve bushing (6) in engine block (1) using remover and installer and ball-peen hammer.
6.
If removed, install two plugs (5) and two pins (2 and 3) in engine block (1) with ball-peen hammer.
NOTE
For loader backhoes equipped with engine coolant heater, skip step 7.
7.
Install draincock (12) and pipe plug (13) in engine block (1).
8.
Install four pipe plugs (14) in engine block (1).
FOLLOW-ON TASKS:
NOTE
Perform the following on all loader backhoes.
•
Install liquid level gage (see TM 5-2420-222-20).
•
Install crankshaft (see paragraph 3-8).
•
Install cylinder sleeves (see paragraph 3-5).
•
Install flywheel housing (see paragraph 3-10).
•
Install lubricating cooler (engine oil cooler) (see TM 5-2420-222-20).
•
Install starter (see TM 5-2420-222-20).
•
Install cylinder block plate (see paragraph 3-7).
•
Install engine assembly (see paragraph 3-3).
NOTE
Perform the following only on loader backhoes equipped with engine coolant
heater.
•
Install engine coolant heater (see TM 5-2420-222-20).
•
Install engine coolant heater hoses and fittings (see TM 5-2420-222-20).
3-31
|
