|
| |
TM5-2420-222-34
14-10
BACKHOE STABILIZER AND BUCKET VALVES REPAIR (Con’t).
4.
Hold clevis rod end (7) to prevent turning, and remove bolt (20) from spool plug (13).
5.
Remove spool spring (19), spring pin (18), and two washers (17) from valve body (2).
6.
Remove valve (12), sleeve bushing (16), and two preformed packings (14 and 15) from valve body (2). Discard
preformed packings.
NOTE
Step 7 applies only to stabilizer valves.
7.
Remove fluid flow restrictor (8) from valve body (2).
8.
Wrap valve (12) in clean rag and place In vise with caps.
NOTE
Ensure that spring and fluid flow restrictor do not fall out when clevis rod end and
preformed packing are removed.
9.
Remove clevis rod end (7) and preformed packing (9) from valve (12). Discard preformed packing.
NOTE
Step 10 applies only to stabilizer valves.
10.
Remove spring (10) and fluid flow restrictor (11) from valve (12).
11.
Remove spool plug (13), spring (23), preformed
packing (21), and fluid flow restrictor (22) from valve
(12). Discard preformed packing.
TA701581
14-51
|
