|
| |
TM 5-2420-222-34
3-3.
ENGINE ASSEMBLY REPLACEMENT (Con’t).
3.
Install three “ in. -13 UNC threaded eyebolts (36) in lift points of cylinder head (38).
4.
Position lifting device over engine assembly (39). Connect engine and transmission sling (37) to eyebolts (36)
and to lifting device.
WARNING
•
Use extreme caution when handling heavy parts. Lifting device is required when parts weigh
over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over
150 lb (68 kg) for a three or more person lift. Keep clear of heavy parts supported only by
lifting device. Failure to follow this warning may cause serious injury or death to personnel.
•
Parts of clutch assembly will be coated with asbestos dust. Breathing this dust may be
hazardous to your health. Use an approved filter mask for use against asbestos dust. Never
use compressed air or a dry brush to clean these parts. Dust must be removed with an
industrial-type vacuum cleaner equipped with a high efficiency filter system.
5.
Using lifting device, raise engine assembly (39) off engine stand or wood blocks and position over loader backhoe.
6.
Install upper engine mount (49) and lower engine mount (54) in left and right brackets (46).
TA701230
3-15
|
