|
| |
TM 5-2420-222-34
13-5.
COWL SUPPORT MAINTENANCE (Con’t).
3.
Remove warning light flasher and bracket (see TM 5-2420-222-20).
4.
Remove speed control shaft (32) from cowl support (7).
c.
CLEANING AND INSPECTION
1.
Clean cowl support and assembled cowl barriers with clean rags and a solution of water and detergent. Rinse with
clean water and dry thoroughly with clean, dry rags.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with
skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open
flame or excessive heat. The solvent's flash point is 100°F-138°F (38°C-59°C). If
you become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts eyes, Immediately wash your eyes and get
medical aid.
2.
Clean all other metal parts with dry cleaning solvent and rags. Dry thoroughly with clean, dry rags.
3.
Inspect all metal parts for cracks, breaks, and abnormal bends.
4.
Inspect cowl barriers for cracks, rips, tears, and crumbling.
d.
ASSEMBLY
NOTE
Perform steps 1 and 2 only If cowl barriers were removed.
1.
Apply metal bonding adhesive in 8 in. (3.18 mm) wide beads in 2 in. (50.80 cm) or smaller squares on cowl barrier
(29, 34, or 35). Ensure that outside bead has no gaps and is within 1/4 in. (6.35 mm) from edge of cowl
2.
Press cowl barrier (29, 34, or 35) in place on cowl support (7), then remove and allow adhesive to set for two minutes.
Aline cowl barrier with cowl support and press firmly in place.
3.
Install speed control shaft (32) in place on cowl support (7).
4.
Install warning light flasher and bracket (see TM 5-2420-222-20).
e.
INSTALLATION
1.
Install cowl support (7) in place on steering column (16) and reverser housing (25).
2.
Install two capscrews (30), new lockwashers (31), and angle bracket (33) in cowl support (7) and reverser housing
(25).
13-29
|
