|
| |
TM 5-2420-222-34
10-3.
SERVICE BRAKE DISK AND PRESSURE PLATE REPAIR (Con’t).
19.
Remove packing retainer (18) and tool holder from transmission (14).
20.
Inspect transmission braking surface (20) for scores. All score marks should be removed. If score marks remain,
repeat steps 11 through 20.
21.
Using combination square and micrometer depth gage, measure distance from machined surface of transmission
(14) to transmission braking surface (20).
22.
Distance recorded in step 21 must not exceed 1.210 in. (30.734 mm). If distance exceeds specification, remove,
disassemble, and replace transmission housing (see paragraph 8-2).
NOTE
Step 23 applies only to left transmission braking surface.
23.
Remove final drive shaft (22) from collar (27), drive shaft hub (21), and differential bevel gear (23).
NOTE
Step 24 applies only to right transmission braking surface.
24.
Remove final drive shaft (25) from drive shaft hub (26) and differential bevel gear (24).
10-17
|
