|
| |
TM 5-2420-222-34
10-3.
SERVICE BRAKE DISK AND PRESSURE PLATE REPAIR (Con’t).
8.
Install final drive shaft (22) through collar (27), drive shaft hub (21), and differential bevel gear (23).
NOTE
Step 9 applies only to right transmission braking surface.
9. Install final drive shaft (25) in drive shaft hub (26) and differential bevel gear (24).
10.
10.
Install tool holder and assembled cutting blades on final drive shaft (22 or 25) with cutting blades facing
transmission braking surface (20).
11.
Position packing retainer (18) onto tool holder so that holes aline with transmission (14).
12.
Using key and combination square, install six socket head capscrews, washers, and R26125 valve springs in
packing retainer (18) and transmission (14) until washers are 1A in. (3.81 cm) from surface of brake disk (17).
13.
Check transmission fluid level (see LO 5-2420-222-12).
14.
Start engine assembly (see TM 5-2420-222-10).
15.
Engage differential lock and shift transmission into fourth gear (see TM 5-2420-222-10).
NOTE
Step 16 applies only to right transmission braking surface.
16.
Shift reverser into reverse, engage clutch, and accelerate engine enough to prevent stalling (see TM 5-2420-222-
10). Operate for one minute.
17.
Shut down engine assembly (see TM 5-2420-222-10).
18.
Using key, remove six socket head capscrews, washers, and valve springs from packing retainer (18) and
transmission (14).
TA701466
10-16
|
