|
| |
TM 5-2420-222-34
9-3.
REAR AXLE HOUSING, SHAFTS, SEALS, BEARINGS, AND PLANETARY PINION CARRIER MAINTENANCE
(Con’t).
30. If preload was too great, remove one 0.005 in. (127 mm) shim (34). If preload was too little, add one 0.005 in. (127
mm) shim. Repeat steps 26 through 29.
31. Install lockplate (29) on screw (30) and planetary pinion carrier (32). Tighten screw as required to seat lockplate.
32. Install connector (17) and new preformed packing (18) in rear axle housing (1).
33. Install new grease fitting (16) in rear axle housing (1).
34. Install connector (22) and new preformed packing (21) in rear axle housing (1).
TA701449
9-23
|
