|
| |
TM 5-2420-222-34
7-2.
ENGINE STARTER REPAIR (Con’t).
36.
Repeat step 35 for brushes (32) and drive screws (33).
NOTE
Steps 37 through 40 apply only when installing new brushes.
37.
Lift new brushes (32 and 38) off commutator (58) and hold. Using masking tape and fine abrasive paper with
rough side facing out, cover commutator.
38.
Release brushes (32 and 38) and slowly rotate armature (9) in main housing (2) until brushes seat on commutator
(58).
39.
Lift brushes (32 and 38) and remove fine abrasive paper and masking tape from commutator (58).
CAUTION
Ensure that all dust and abrasive particles are removed after seating new brushes.
If not. commutator and brushes can be damaged or wear rapidly.
TA701356
7-28
|
