|
| |
TM 5-2420-222-34
7-2.
ENGINE STARTER REPAIR (Con’t).
20.
Remove four screws (47), lockwashers (53), and nuts (54) from main housing (2), two supports (30), and leads
(29). Discard lockwashers.
21.
Remove two supports (30) and leads (29) from main housing (2).
22.
Remove wick end (46) from electrical end bell (5).
NOTE
Some loader backhoes do not have pipe plug and wick.
23.
Remove pipe plug (56) and wick (57) from electrical end bell (5).
CAUTION
Do not remove sleeve bushing unless damaged. Removal may damage parts.
24.
Using gear and bearing mechanical puller, remove sleeve bushing (55) from electrical end bell (5).
25.
Remove pipe plug (51) and wick (50) from drive housing (1).
CAUTION
Do not remove sleeve bushing or straight pin unless damaged. Removal may damage parts.
26.
Using arbor press and inside diameter remover and installer, drive out sleeve bushing (49) from drive housing (1).
27.
Remove straight pin (48) from main housing (2).
TA701348
7-19
|
