|
| |
TM 5-2420-222-34
7-2.
ENGINE STARTER REPAIR (Con’t).
16.
Remove self-locking bolt (44), lockwasher (43), two wire terminals (45), and angle bracket (6) with grommet (42)
from main housing (2). Remove grommet from angle bracket. Discard self-locking bolt and lockwasher.
CAUTION
Do not remove coil, pole pieces, and retaining screws unless damaged. Be careful
when handling these parts. Scraping Insulating varnish from coil assembly could
cause grounding to main frame or pole shoes, or shorted windings.
NOTE
If not removing coil, pole pieces, and retaining screws, skip steps 17 and 18.
17.
Remove eight machine screws (41) from main housing (2) and four pole pieces (40)
18.
Remove coil (39) and four pole pieces (40) from main housing (2). Remove pole pieces from coil.
CAUTION
Do not remove riveted support unless damaged. Removal will damage rivets.
NOTE
•
Some supports and leads are secured with rivets, some with screws,
lockwashers, and nuts. If parts are secured with rivets, perform step 19. If parts
are secured with screws, lockwashers, and nuts, skip step 19 and perform step
20.
•
Supports and leads having rivets will use screws, lockwashers, and nuts for
assembly.
19.
Using portable electrical drill, drill out four rivets (52) from main housing (2), two supports (30), and leads (29).
Discard rivets.
TA701347
7-18
|
