|
| |
TM 5-2420-222-34
4-4.
CLUTCH DISK CARRIER OR CLUTCH SUPPORT BEARING CARRIER MAINTENANCE.
This Task Covers:
a.
Removal
d.
Assembly
b.
Disassembly
e.
Installation
c.
Cleaning and Inspection
Initial Setup.
Equipment Conditions:
Materials/Parts:
•
Clutch manual control lever removed (see
•
Rags (Item 28, Appendix B)
paragraph 4-3). * Dry cleaning solvent (item 31, Appendix B)
•
One preformed packing
•
One seal
Tools/Test Equipment:
•
One preformed packing
•
General mechanic's tool kit
•
Eight lockwashers
•
Field automotive shop set
•
Clutch alining tool
General Safety Instructions:
•
Vacuum cleaner
•
Dry cleaning solvent is flammable and must not be
used near open flame. Use only in a well-ventilated
•
DO NOT use a dry brush or compressed air to clean
clutch assembly or clutch components.
WARNING
Parts of clutch assembly will be coated with asbestos dust. Breathing this dust
may be hazardous to your health. Use a filter mask approved for use against
asbestos dust. Never use compressed air or a dry brush to clean these
assemblies. Dust shall be removed using an industrial-type vacuum cleaner
equipped with a high efficiency filter system.
a.
REMOVAL
1.
Remove eight screws (1) and lockwashers (2) from carrier (3) and reverser housing (4). Discard lockwashers.
2.
Remove carrier (3) with attached parts from reverser housing (4).
b.
DISASSEMBLY
1.
Remove preformed packing (5) from carrier (3). Discard preformed packing.
2.
Using gear and bearing mechanical puller, remove seal (6) from carrier (3). Discard seal.
4-18
|
