|
| |
TM 5-2420-222-20-3
LOADER CONTROL VALVE-TO-LOADER BOOM CYLINDER ROD END OIL LINES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
35.
Adapter (1)
Hose (2)
a.
Take off tag.
b.
Screw on and tighten using 7/8-inch
and 1-inch open-end wrenches.
36
Hose (2) and
Clamp (4)
Screw on and tighten to same relative
loader boom
position as noted during removal using
cylinder (3)
1/4-inch flat-tip screwdriver.
37.
Loader
Transmission
Check fluid level and add proper amount
backhoe
and grade (TM 5-2420-222-10).
38.
Engine
Start and run at high idle
(TM 5-2420-222-10).
39.
Loader control
a.
Operate lift arms (TM 5-2420-222-10)
valve-to-loader
and check for leaks.
boom cylinder
b.
If leaking at any connection, tighten
rod end oil lines
using 7/8-inch and 1-inch open-end
wrenches.
c.
If leaking does not stop, shut down
engine CTM 5-2420-222-10) and
replace leaking connection packing,
hose, or fitting as outlined in this
task.
d.
If found leaking, repeat steps 37
thru 39.
40.
Engine
If still running, shut down
(TM 5-2420-222-10).
2-1696
|
