|
| |
TM 5-2420-222-20-3
CLUTCH CONTROL VALVE-TO-HYDRAULIC PUMP INLET OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
26. Oil pan (1)
Two brackets (2)
Place in position.
27. Two brackets (2),
Two screws (4) and
a.
Screw in and tighten until snug using
oil pan (1), and
new lockwashers (5)
9/16-inch, 1/2-inch drive socket, 5-
engine block (3)
inch extension, and ratchet handle.
b.
Using 9/16-inch, 1/2-inch drive
socket, 5-inch extension, and 0 to 150
foot-pound torque wrench, tighten to
50 foot-pounds (68 N m) torque.
28. Two brackets (2)
Two clamps
Place in position.
and three oil lines
(9 and 10)
(6 thru 8)
29. Two clamps (9 and
Two screws (11), new
Screw together and tighten using 1/2-
10) and two
lockwashers (12),
inch, 1/2-inch drive socket, ratchet
brackets (2)
and nuts (13)
handle, and 1/2-inch open-end wrench.
30. Clutch control
Oil line (15) with
a.
Unplug valve (14).
valve (14) and
assembled parts and
b.
Place in position.
clamp (9)
new packing (16)
c.
Take off tag.
31. Hose (17), clamp
Oil line (19)
a.
Take off tag.
(10), and
b.
Uncap elbow (18).
elbow (18)
c.
Place in position.
d.
Screw onto elbow (18) using 1 1/2-inch
open-end wrench.
32. Hose (17)
Clamp (20)
Using 1/4-inch flat-tip screwdriver, tighten.
33. Two clamps (9 and
Two hose clamps (21)
Place in position.
10) and five oil
lines (6 thru 8,
15, and 19)
34. Two hose clamps (21)
Two screws (22),
Screw together and tighten using 7/16-
washers (23), and
inch, 1/2-inch drive socket, ratchet
nuts (24)
handle, and 7/16-inch open-end wrench.
35. Clutch adapter (25)
Special washer (26)
Place in position.
and oil line (6)
2-1358
|
