|
| |
TM 5-2420-222-20-2
REFLECTORS (SERIAL NUMBERS 319995 THRU 342573 ONLY) - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING - CONTINUED
1. Lamp plate (1)
Reflector (2)
a. Using clean rag dampened with solution
of detergent and water, wipe clean.
b. Rinse with clean water.
c. Using clean, dry rags, wipe dry.
INSPECTION/REPLACEMENT
NOTE
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-137).
Replace defective parts as needed.
2. Lamp plate (1)
Reflector (2)
Look for cracks and breaks.
REMOVAL
NOTE
Do not remove reflectors unless inspection shows need for replacement.
WARNING
Water soluble cleaning compound solvent is flammable and fumes are toxic. Flashpoint is 2200F
(104oC). Boiling point is 212°F (100oC). Do not store in temperatures above 150°F (65oC) or below 35°F
(2oC). Do not use near open flame or excessive heat. Do not wear jewelry, wear rubber gloves and
goggles, and use only in well ventilated area. Avoid contact with skin, eyes, and clothes, and don't
breathe vapors. Avoid contact with acids, aluminum, or zinc; chemical reaction may result. If you become
dizzy while using cleaning compound solvent, get fresh air immediately and get medical aid. If contact
with eyes is made, wash your eyes with water and get medical aid immediately.
3. Lamp plate (1)
Reflector (2)
a. Note position for proper placement
during installation.
b. Using cleaning compound solvent, dis-
solve adhesive and take off.
c. Using clean rag soaked in cleaning
compound solvent, remove all adhesive
from lamp plate (1) and reflector (2).
d. Rinse lamp plate (1) and reflector (2)
with water.
e. Using clean, dry rags, wipe dry.
2-1180
|
