|
| |
TM 5-2420-222-20-2
TIE ROD - CONTINUED
INITIAL SETUP - CONTINUED
Materials/Parts
Materials/Parts - Continued
Detergent, GP (item 7, Appendix C)
NOTE
Grease (LO 5-2420-222-12)
Lockwasher, clamp screw
The following part only applies
(two required)
to loader back hoes with Serial
Pin, cotter, left steering cylinder
Numbers 235786 thru 235999.
pin
Pin, cotter, tie rod stud
Pin, cotter, right steering cylinder pin
(two required)
Rags, wiping (item 21, Appendix C)
Personnel Required
Solvent, drycleaning
(item 28, Appendix C) One
Equipment Condition
Hydraulic system pressure released
(page 2-1191)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Loader backhoe
Front wheels
Turn all the way right (TM 5-2420-222-10).
NOTE
Loader backhoes with Serial Numbers 235786 thru 235999 have two steering cylinders. Loader
backhoes with Serial Numbers 319995 thru 342573 have one on left side. Left side is shown. On
loader backhoes with Serial Numbers 235786 thru 235999, repeat steps 2 thru 4 for right side.
2.
Steering arm (1)
Cotter pin (3)
a.
Using multiple tongue and groove slip-
and pin (2)
joint pliers, straighten ends and take
out.
b.
Get rid of.
3.
Steering arm (1)
Pin (2)
Using 3-pound cross-peen head hammer
and steering
and 3/4-inch brass-tipped drift pin,
cylinder (4)
drive out.
4.
Steering arm (1)
Steering
Move out of way.
cylinder (4)
5.
Loader backhoe
Front wheels
a.
On loader backhoes with Serial Numbers
235786 thru 235999, turn all the way
left (TM 5-2420-222-10).
2-928
|
