TM 5-2420-222-20-2 HYDRAULIC OIL COOLER - CONTINUED ACTION LOCATION ITEM REMARKS INSPECTION/REPLACEMENT - CONTINUED 18. All threaded parts Look for damaged threads. REPAIR 19. Oil cooler Repair (TM 750-254). INSTALLATION 20. Oil cooler (1) Two baffles a. If removed, apply metal adhesive. (2 and 3) b. Press into place to transfer some metal adhesive. c. Take off and allow metal adhesive to set for about 2 minutes. d. Press firmly into place. 21. Front support (4) Rubber washer (5) Place in position. 22. Four radiator studs Oil cooler (1) Place in position. (6), fan shroud (7), front support (4), rubber washer (5), and hoses (8) with assembled clamp (9) 23. Oil cooler (1) Hose (10) with Put on. assembled clamp (11) 24. Hose (10) Clamp (11) Using 3/16-inch flat-tip screwdriver, tighten. 25. Four radiator Four washers (12), Screw on and tighten using 1/2-inch, studs (6) and new lockwashers 3/8-inch drive socket, 5-inch extension, oil cooler (1) (13), and nuts (14) universal joint, and ratchet handle. 26. Oil cooler (1) Two screws (15) Screw in and tighten using 5/16-inch and fan shroud (7) flat-tip screwdriver. 27. Hose (8) Clamp (9) Using 3/16-inch flat-tip screwdriver, tighten. 28. Screw (16) Spring (17) Put on. 29. Oil cooler (1) and Screw (16) with Screw in and tighten using 9/16-inch, front support (4) assembled 3/8-inch drive socket, 5-inch extension, spring (17) and ratchet handle. 2-846