|
| |
TM 5-2420-222-20-2
SPEED GEAR ASSEMBLY (REVERSER) CONTROL LEVER LINKAGE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
47.
Operator’s
Transmission range
Put in high range (II) position
compartment
shift lever
(TM 5-2420-222-10).
48.
Speed gear assembly
Put in forward drive position
(reverser)control
(TM 5-2420-222-10).
lever
49.
High speed
Control shaft
Using thickness gage, check clearance
lockout pin (1)
arm (2)
between pin (1) and arm (2).
Correct clearance is 0.060-inch
(1.524 mm).
NOTE
If clearance between pin and arm is correct, skip steps 50 thru 60.
50.
Control lever rod
Nut (5)
Using 9/16-inch open-end wrench,
(3) and yoke (4)
loosen.
51.
Headed pin (6)
Cotter pin (7)
a.
Using slip-joint pliers, straighten
ends and take out.
b.
If not just replaced during assembly,
get rid of.
52.
Washer (8)
Take off.
53.
Clutch control
Headed pin (6)
Take out.
valve shaft (9)
and yoke (4)
54.
Clutch control
Yoke (4)
Take off.
valve shaft (9)
55.
Control lever
Yoke (4)
a.
If clearance between high speed lockout
rod (3)
pin (1) and control shaft arm (2) is
less than specification, turn clockwise
to increase clearance.
b.
If clearance between high speed lockout
pin (1) and control shaft arm (2) is
greater than specification, turn counter-
clockwise to decrease clearance.
2-824
|
